SLATE SEALER- Dry Finish (Sample,1 & 5L) Highly Durable, Stain Resistant
(Sample, 1 & 5 litre) Stain Resistant, Durable, Breathable Impregnating Sealer- Easy to Apply. Impregnating 'Invisible' sealer for Slate: Coverage up to: 10 m² per litre
Natural Stone Sealer with a 'DRY' Invisible Finish suitable for Slate
Effective impregnating sealer for sandstone, limestone, granite and slate
Smartseal Indian Sandstone Sealer and Natural Stone Sealer is a high quality, clear, solvent free acrylic impregnating, breathable coating system. Application of the sealer will alter the chemical structure of the porous sandstone or natural stone providing a excellent water repellent and stain resistant surface.
- One coat application to saturation, or (for best results apply 2nd coat 'touch dry')
- Resistant to algae, lichen and staining
- Dry finish
- Application by roller or sprayer
- Fully waterproof 24 hours
- Suitable for Sandstone, Limestone, Terracotta, Travertine, Slate and Granite
- Can be used externally or internally
PREPARATION: Pre treat surface with appropriate cleaning product. If required, fully clean off using a pressure washer and leave to dry thoroughly for at least 3 days. In order to apply sandstone or natural stone sealer, the area must be clean, dry and free from contamination.
Always test product on-site, in an inconspicuous area, to ensure you fully are satisfied with the final appearance/ colour of the surface.
**If applied to a surface where a "sweep-in" pointing compound has been used within the last 6 months, the natural stone must be fully cleaned with Smartseal Residue Remover prior to sealant application.**
APPLICATION NOTE: Application on vertical surfaces should be to full saturation commencing at the bottom and working upwards. Do not apply in damp conditions and only apply to dry surfaces in temperatures above 13°C and no higher than 23°C. It is very important to make sure no rain is forecast for at least 8 hours after application.
Depending on the stone/surface, more than one coat may be required. For most porous stones, a 2nd lighter coat can be applied once touch dry (slightly wet). If over application does occur on either coats, excess sealer can be removed with a dry roller or sponge. Ensure this is done within 45 minutes.
- Shake container well before use
- Ensure that surface area is completely clean from dirt & grime.
- Allow surface area to dry, will take 2-3 dry days depending on the weather.
- Apply 1st coat to saturation by roller, sprayer or brush.
- Apply 2nd lighter 'mist' coat (approx 45 minutes after 1st coat if suitable).
- If over application does occur, please remove excess sealer with a dry sponge or cloth.
- Avoid walking on surface 4 hours after application and 24 hours for heavy traffic.
All equipment should be cleaned with water immediately after use.
SHELF LIFE: Store away from direct sunlight and sources of heat. Protect from frost.
12 months shelf life (in original sealed container). Once opened use within 3 months.
Q: Hi - I am looking for a product to put onto new Spanish slate tiles to reduce the solar glare that they have when the sun is at a particular angle. Do you have something that specifically combats the reflective properties of the slates? Thanks
A: Unfortunately, we do not sell a product that specifically combats the reflective properties of the slates.
Q: what product would you suggest for a shower with slate floor? would prefer matt finish or possibly satin but not gloss.
A: The Dry Finish slate sealer would be the correct product (sample available) This will not adversly affect the slip resistance of the slate. Hope that helps.
We provide a national delivery service for our block paving sealer, pattern imprinted concrete sealer, roof coatings and tarmac restorer on a standard 2 - 4 working day basis. Dependent on weight, this is normally done by pallet or parcel carrier.
If you need products delivered quicker, for a small additional charge, orders placed before 1.30pm can be delivered within 1 - 2 working days to most parts of the UK, although this is dependent on the courier service in your area and the product/s ordered. If you require this service, please check on area availability by calling 01268 722500.
Our commitment is to supply all orders as placed and we offer a comprehensive guarantee of quality. Providing a reliable delivery service to all our customers is most important to us and this is backed up by the many satisfied customer testimonials we have received over the years.
If you need an order delivered to a different address, left somewhere at your property without a signature or left with a neighbour, just let us know.
We also try to maintain 100% stocking levels of our products at all times, so an immediate despatch is virtually guaranteed.
Our product returns policy can be viewed by visiting our Terms and Conditions section.
*Free delivery on orders over £75 are subject to the delivery address location.
Happy with the sealer its brought the limestone up nicely.
Helpful webchat advice to suggest a sample to test compatibility with whatever sealer was used previously. Coverage consistent with product guidance. Easy to apply (I used a mop) and nice finish, but after just a few days, impossible to assess how well it will wear.
A good product which served its purpose